[COMPLETED] Community Service Project: Checkout Counter for Lighthouse
Organization: Lighthouse Louisiana,
Project: Checkout Counter,
Status: Completed,
Projected Start Date: 2/15/2019,
Deadline: TBD,
Participating Members:
3 Teams (shop owner is listed first):
- [Desk Cabinet Assembly] Keith Bryan. Richard Robles, Robert Aucoin;
- [Low Counter Assembly] Brian Fitzgerald, Mike Lee, Bob Bewick;
- [Rest & Install] Lee Soileaux, Ken Brown, and a draft choice to be named later.
Design & Plan:
Checkout counter and cabinets for their retail store. Cabinets to be a mix of drawers and doors. This piece is designed by Kesh Ikuma with inputs from Terry Landry.
The plan was drawn in Autodesk Fusion 360, which is a 3D modeling software with rich features. The model and drawings are embedded below for your reference.
Club Supplied Materials: Drawer Slides, Drawer Pulls, and Door Knobs
Member Supplied Materials: Red oak plywood (3/4″) & lumber (for visible parts), 1/2″ plywood (for drawers), 1/8″x1/2″ metal bar stock (for file drawer), and 2×4 pine (for base)
Budget for Member Supplied Materials: $???
Build Notes:
Red oak ply is available at Home Depot at $56/sheet; it is considerably higher at Brazos, Service, Holmes, etc.
Finishing will have to be done at the same time and place to assure uniformity; where and when to be worked out later.
Any questions should be addressed to Lee Owens (leeo2000@cox.net) and Kesh Ikuma (tikuma@hotmail.com).
Fusion 360 Model & Drawings
Link to the Fusion 360 Model (downloadable): https://a360.co/2SSbjhf
Leave a Reply
You must be logged in to post a comment.